Carmel Forge, located in Tirat Hakarmel, ISRAEL, is active in hot conversion by close-die forging and rolling of special steels, superalloys & titanium.

The main products are Torque Frame, Disc, Gear, rotating seal, bearing housing, Case, ring, Rotor, Flange, Hub, impeller, stub shaft produced by closed-die forgings and rolled seamless rings.

Production Capabilities

  • A unique combination of Closed Die forging & Ring Roller
  • Forging & Ring Roller simulation
  • Die design and production
  • Pre-forming 2400 tons hydraulic press
  • Closed die forging – 2 X 12,000 tons computer-controlled screw presses
  • Fully automated ring-rolling line 250 tons vertical & horizontal
  • Computer controlled electrical heat treatment furnaces
  • Solution Aging, Tempering, Quenching (oil, water, and forced air)
  • Machine Shop
  • Fully automated ultrasonic immersion lab. etching & FPI Lines
  • Water jet cutting & EDM (specimen extraction)
  • Fully equipped metallurgical & mechanical laboratories

Production envelope

  • Discs, Gears, Impellers, Hubs, and Stub-shafts torque frames up to 450mmØ (Nickel Base) to 650 mmØ (Titanium Base) and with a weight of 400Kg (880lb)
  • Cases, Seals, rings, flanges, Rotating seals, (Seamless Rings) up to 1800 mm OD and a weight of 450 Kg (1000 lb)

DISK LPC – Ti 6-4

COMPRESSOR HUB – SAE 4340

HPC HUB – Ti 6-4